Application of sizing machine
Designed with versatility in mind, this sophisticated machine accommodates a broad spectrum of yarn types, including innovative and traditional materials such as cotton, linen, synthetic, blended yarns, Tencel, and Modal. It is capable of handling yarn sizes from Ne10 to Ne120, with total warp ends ranging impressively from 1500 to 32,000. This remarkable adaptability makes it an ideal solution for modern textile challenges.
Detailed Photos
Based on KarlMayer,All roller diameters have been increased, bearing specifications have been increased, and the pillars and wall panels of the drying room have been thickened.
Our machine total weight is more than 30 tons.KarlMayer weight is less than 30 tons.
The winding and clamping method is reasonable. Karl Mayer uses a screw to drive a mobile trolley to achieve the tightness of the weaving shaft. However, the copper nut on the screw is prone to wear. We not only use a mobile trolley, but also use pneumatic clamping. For weaving shafts of the same size, pneumatic clamping can be used directly without using a mobile trolley to achieve the tightness of the weaving shaft.
The slurry tank reduction motor is installed horizontally, while Karl Mayer is installed vertically. The motor is located below the reduction gearbox. This structure will indirectly damage the motor and encoder when the oil seal in the gearbox wears out and all the gear oil flows into the motor.
Product Parameters
| 2 sizing box |
9 unit-inverter control |
| working width |
3600mm * dia.1000mm |
| sizing box width |
2000mm |
| dryer drum |
14pc dia.800*2200 |
| beam creel |
6 unit,can load 24pcs beam |
| Control system |
9 unit inverter control |
| design speed |
0-150m/minitue |
| Sizing machine |
| 1 size box |
Working width (cm) |
280-360 |
|
|
| Control system |
5 unit inverter |
6 unit inverter |
6 servo motor |
| |
|
|
|
|
| Warping machine |
| 2 size box |
Working width (cm) |
280-360 |
|
|
| Control systerm |
7 unit inverter |
7 servo motor |
9 servo motor |
| |
|
|
|
|
| Batch warping machine |
| working width |
180cm,200cm,240cm,260cm |
| creel bobbin |
720pcs,800pcs,1000pcs |
| |
|
|
|
|
| Accessories for sizing |
| 1.warp beam |
beam size 180cm,200cm,240cm,260cm |
| 2.air compressor |
air pressure 6bar |
| 3.boiler |
2 tons is enough |
| 4.size mixer |
2 small,1 big |
){kind=link}